Setting The Wireless Sensor Transmitter; Programming The Weather Station; Low Battery Warning - Clas Ohlson WS2068HL+WT450H Manual

Starting Up
First set the wireless sensor transmitter so that the weather station receives a
radio signal from the sensor when it is activated.
Step 1: Setting the wireless sensor transmitter
1. Remove the battery cover and insert 2x LR6
batteries (not included), according to the
markings on the battery compartment.
2. The house code (01H) will flash on the
display for 8 seconds.
3. Change the code by pressing [°C/°F] (7)
repeatedly, setting 1 to 15.
4. Set all the wireless sensor transmitters (one
sensor is included) to the same setting,
press [Set] (6), the channel ( "1" on the left
side of the display) will flash for 8 seconds.
5. Change channel by pressing [°C/°F] (7) repeatedly, setting 1 to 4, press [Set]
(6).
6. The humidity and temperature appear on the display.
7. Choose a temperature display in °C or °F by pressing [°C/°F] (7).
8. Replace the cover on the battery compartment.
The normal setting for the house code and channel is "01". Change the weather
station's house code or channel if it receives signals from other neighbouring
transmitters or sensors.
Step 2: Programming the weather station (receiver/base unit)
1. Remove the battery cover and insert 3 x
LR6 batteries (not included), according to
the markings on the battery compartment.

Low battery warning

Weather station (receiver): A horizontal low battery warning symbol will appear
on the display.
Sensor transmitter: A vertical "low battery" warning symbol will appear on the
display.
SET
1
1
1
6
3 5 7
C/F
1
2
4
1
6
1
%
1
3 5 7
SET C/F
1
2
1
4
1
6
1
1
%