Control Panel - Zanussi ZJB9476 User Manual

Environment Protection
This appliance does not contain gasses which could
damage the ozone layer, in either its refrigerant cir-
cuit or insulation materials. The appliance shall not be
discarded together with the urban refuse and rubbish. The

Control panel

1 2 3 4
1. Pilot light
2. ON/OFF switch
3. Temperature regulator (warmest)
4. Temperature indicator
5. Temperature regulator (coldest)
6. Alarm light
7. Alarm reset switch
8. Action Freeze light
9. Action Freeze switch
Switching on
Insert the plug into the wall socket.
Press the ON/OFF switch .
The Pilot Light will light up.
Switching off
The freezer is shut off by pressing the ON/OFF switch until
the Pilot light and the Temperature indicator switched off.
Temperature regulation
The temperature can be adjusted between -15°C and
-24°C.
By pressing the Temperature regulators , the current tem-
perature setting flashes on the Temperature indicator. It
is possible to modify the setting temperature only with
flashed indicator. To set a warmer temperature, press
warmest Temperature regulator . To set a colder temper-
ature, press coldest Temperature regulator. The Temper-
ature indicator displays the newly selected temperature
for a few seconds and then shows again the inside com-
partment temperature.
The newly selected-temperature must be reached after 24
hours.
4
Freezer Control panel
5 6 7 8 9
insulation foam contains flammable gases: the appliance
shall be disposed according to the applicable regulations
to obtain from your local authorities. Avoid damaging the
cooling unit, especially at the rear near the heat exchang-
er. The materials used on this appliance marked by the
symbol are recyclable.
Caution! During the stability period by the first
starting the temperature displayed can not
correspond to the setting temperature.
Temperature indicator
During normal functioning the Temperature indicator
shows the temperature inside the freezer.
Important! Difference between the temperature displayed
and temperature setting is normal. Especially when:
• a new setting has recently been selected.
• the door has been left open for a long time.
• warm food has been placed in the compartment.
Excessive temperature alarm
In the event of an abnormal temperature rise inside the
freezer (e.g. power cut) Alarm light will start to flash and
a buzzer will sound.
After the temperature has returned to normal, the Alarm
light will continue to flash, although the buzzer has stop-
ped.
When the Alarm reset switch is pressed, the warmest
temperature reached in the compartment flashes on the
Temperature indicator .
If the power has been off for a long time, frozen food
should be consumed as quickly as possible, or cooked
and then re-frozen.
Action Freeze function
You can activate the Action Freeze function by pressing
the Action Freeze switch.
The Action Freeze light will light up.
When this function is on, SP is shown on the dispay .