Technical Data; Installation - Zanussi ZJB9476 User Manual

Problem
The temperature in the refrigera-
tor is too high.
The temperature in the freezer is
too high.
There is too much frost.
Replacing the lamp
1. Disconnect the mains plug from the mains socket.
2. Remove the lamp
cover (refer to the
illustration).
3. Replace the used
lamp with a new
lamp of the same
power and specifi-
cally designed for
household appli-

Technical data

Dimension of the recess
Rising Time
The technical information are situated in the rating plate
on the internal left side of the appliance and in the energy
label.

Installation

Positioning
Install this appliance at a location where the ambient tem-
perature corresponds to the climate class indicated on the
rating plate of the appliance:
10
Possible cause
The product temperature is too high.
Many products are stored at the same
time.
There is no cold air circulation in the
appliance.
Products are too near to each other.
Food is not wrapped correctly.
The door is not closed correctly.
Height
Width
Depth
Let the product temperature decrease to
room temperature before storage.
Store less products at the same time.
Make sure that there is cold air circula-
tion in the appliance.
Store products so that there is cold air
circulation.
Wrap the food correctly.
Refer to "Closing the door".
ances. (the maximum power is shown on the lamp
cover).
4. Connect the mains plug to the mains socket.
5. Open the door. Make sure that the lamp comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Con-
tact the Service Center.
1900 mm
860 mm
550 mm
14 h
Solution