Accessing Mlc 62 Rs Eu And Mlc 62 Rs Mk Side And Rear Panel Features - Medialink MLC 62 IR D User Manual

Accessing MLC 62 RS EU and MLC 62 RS MK Side and Rear Panel Features

To access the MLC 62 RS EU or MK side and rear panel features after the MLC
has been mounted, you must remove the MLC from the installation surface,
leaving the metal mounting bracket attached. (Without the MLC unit to hold it in
place, the wall frame also is removed.) A removal tool (shown at right) is provided
with the product.
To remove the MLC from the mounting surface:
1. Insert the flat tip of the removal tool in the center of the right or left edge of the MLC,
between the MLC and the wall frame, all the way to the line below the arrow on the
tool.
Figure 43.
2. Press the removal tool inward or toward the mounting surface to release the tab
holding the MLC in place in the wall frame.
3. If the MLC does not immediately come free of the frame, pry the unit outward (away
from the wall) until it is free of the installation surface, then lift it out.
To reinstall the MLC, place it in the wall frame, then press the unit into the metal mounting
bracket until all four tabs snap into their slots.
MLC 60 Series MediaLink Controllers • Features, Installation, and Operation
Y
L A
S P
D I
F
O F
M E
O N
L U
V O
Insert to line.
E O
V I D
P C
T E
M U
O P
P T
L A
Inserting the Removal Tool in an MLC 62 EU
42