Ir Learning - Medialink MLC 62 IR D User Manual

IR Learning

The IR learning transceiver sensor on the MLC front or left side panel can receive and
"learn" commands from the infrared remote controls of other devices via the MLC
configuration software. IR Learning enables you to create an IR driver file to control the
projector or input devices such as a DVD player. IR Learning of projector control codes is
necessary only if there is no driver available for your projector or if you need to customize
the driver.
The IR transceiver accepts infrared signals of 30 kHz to 60 kHz. Point the IR remote
control directly at the transceiver for best results. The diagrams below indicate the best
distances and angles at which to hold the remote control.
Figure 33.
Figure 34.
To set up the MLC for IR Learning, use the MLC configuration software (see the
configuration software help file for the procedures).
IR Learning
Receivers
4"–14"
(10–36 cm)
IR Learning on an MLC D Model
4"–14"
(10–36 cm)
IR Learning on an MLC 62 RS EU or MLC 62 RS MK
MLC 60 Series MediaLink Controllers • Features, Installation, and Operation
DISPLAY
ON
OFF
VOLUME
IR Learning Transceiver
MLC 62 RS EU
and MLC 62 RS MK
Left Side Panel
33