Accessing Covered Panel Features After Mounting
After the MLC is installed in the mounting surface, you can still access the
covered front panel features on the MLC D and the side and rear panel features on the
MLC 62 RS EU and MLC 62 RS MK, using the following procedures.
Accessing the Covered MLC D Front Panel Features
After the MLC D is mounted, the following front panel items are covered by the wallplate:
IR sensor, DIP switches,
remove the two screws at the top and bottom of the wallplate and lift it off the MLC, as
shown below.
Figure 42.
button, and USB connector. To access these controls,
Reset
A Y
P L
D I S
F
O F
O N
M E
L U
V O
E O
V I D
P C
T E
M U
O P
P T
L A
MLC 62 D
Wallplate
Removing the MLC D Wallplate
MLC 60 Series MediaLink Controllers • Features, Installation, and Operation
41