Rear Panel Features - Medialink MLC 62 IR D User Manual

Rear Panel Features

See the wiring and installation sections, later in this section, for connection information.
A A
B B
C C
D D
E E
F F
MLC 62 RS D and MLC 64 RS D
Rear Panel
Host/Config port
A
Digital Input port
B
(RS models only)
Relay ports
C
(RS models only)
Figure 10.
A
B
C
GROUND
A A
Rx
Tx
GROUND
1
COMMON
2
1
D D
GROUND
Tx/IR
GROUND
Tx
F F
GROUND
+12 VDC
MLC 62 IR D Rear Panel
IR/S or IR port
D
RS-232 port
E
(RS models only)
Pwr (power) connector
F
MLC 60 Series Rear Panels
Host/Config port — This bidirectional RS-232 serial port can be used for
configuration and firmware updates in the same way as the USB port (see
Left Side Panels on page 10). The baud rate is 9600 bps. This port can be used
as a backup for the USB Configuration port (although you cannot power a device
through it).
Digital Input port (RS models only) — This port enables the MLC to monitor
devices such as push buttons, switches, motion sensors, and moisture sensors and
provides an additional way to trigger functions on the MLC. Connect a switch or a
sensor to this 2-pole captive screw connector to initiate commands via the MLC to
the display device, switcher, or other room devices such as lights or a motorized
screen.
Relay ports (RS models only) — These relays allow control of room devices such
as motorized screens, lights, and projector lifts. They are normally open relays and are
rated at 24 V, 1 A. Low-power devices can be connected directly to the relay ports;
devices requiring more than 24 V can be connected through a third-party low-voltage
controller (LVC).
MLC 60 Series MediaLink Controllers • Features, Installation, and Operation
GROUND
Rx
Tx
I I
GROUND
IR OUT
H H
GROUND
+12 VDC
G
H
I
C C
D D F F
Tx/
2 Tx
1 C
IR
RELAYS PORT B PORT A
RS-232
IR/ S
N/O
+
G G B B A A F F
MLC 62 RS EU and
MLC 62 RS MK Rear Panel
Reset LED
Reset button
DIP switches
Front and
15