Replacing Buttons - Medialink MLC 62 IR D User Manual

4. Replace the faceplate as follows:
a. Hold the MLC with its board against the back of the faceplate, aligning the two
tabs on each side of the unit with the two slots on each side of the faceplate.
Figure 17.
5. Each tab has a ridge that must snap into a slot on the side of the MLC. Press the
MLC into the faceplate until the tab ridges snap into their slots. Check to make
sure that all four tabs are securely in place.

Replacing Buttons

Additional labeled buttons are provided with the MLC and are available to order from the
Extron website. These buttons can be used to replace the factory-installed buttons in the
MLC faceplate.
Each row of single-sized buttons is a single membrane. The entire membrane is removed,
so that the buttons are replaced in rows. To replace buttons on the MLC:
1. Remove the faceplate from the MLC (see
Faceplates
2. From the front of the faceplate, press the button or button pair to be replaced back
through its slot in the faceplate until the membrane containing the buttons is free.
3.
On the back of the faceplate, place the new button or row of
buttons through the one or two slots in which they will be installed.
Line up the two pegs in the upper-left and lower-right corners of the
new button membrane (see the illustration at right) with the holes
located at opposite corners of the empty pair of slots in the faceplate.
Figure 18.
4. Press the two buttons into the faceplate until the pegs on the membrane are seated
in the corresponding holes.
5. Repeat steps 2 through 4 for any additional buttons that you want to replace, then
reattach the faceplate.
MLC 60 Series MediaLink Controllers • Features, Installation, and Operation
D I
S P
L A
O N
Y
V O O F
L U F
M E
P C
V I D
E O
L A
P T
O P
M U
T E
Slot
Replacing the Faceplate (MLC 62 RS EU)
on page 18).
Replacing a Button Row
Ridge on tab
snaps into slot.
Removing and Replacing the
T E
M U
O P
P T
L A
Pegs (2)
23