Pass Switch; Dimmer Switch; Horn Switch; Turn Signal Switch - Yamaha TENERE XT660ZA Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
Right
3

1. Engine stop switch "

2. Start switch "

"

Pass switch "

"
Press this switch to flash the head-
light.

Dimmer switch "

Set this switch to "
beam and to " " for the low beam.

Horn switch "

"
Press this switch to sound the horn.

Turn signal switch "

To signal a right-hand turn, push this
switch to "
turn, push this switch to "
released, the switch returns to the
center position. To cancel the turn
signal lights, push the switch in after it
has returned to the center position.

Hazard switch "

With the key in the "ON" or "
position, use this switch to turn on the
hazard lights (simultaneous flashing
/ "
of all turn signal lights).
The hazard lights are used in case of
EAU12350 an emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
EAU12400
NOTICE
/ "
Do not use the hazard lights for an
" for the high
extended length of time with the
engine not running, otherwise the
battery may discharge.
EAU12500
Engine stop switch "
EAU12460
Set this switch to "
/ "
ting the engine. Set this switch to
". To signal a left-hand
". When
EAU12733
"
"
ECA10061
EAU12660
/ "
" before star-
3-10
" " to stop the engine in case of an
emergency, such as when the vehicle
overturns or when the throttle cable is
stuck.
Start switch " "
Push this switch to crank the engine
with the starter. See page 5-1 for star-
ting instructions prior to starting the
engine.
The engine trouble warning light and
ABS warning light (ABS model only)
will come on when the key is turned
to "ON" and the start switch is pus-
hed, but this does not indicate a mal-
function.
EAU12711
EAU44710