Yamaha TENERE XT660ZA Owner's Manual page 58

PERIODIC MAINTENANCE AND ADJUSTMENT
3. Place an oil pan under the engine
to collect the used oil.
4. Remove the engine oil filler cap
and the drain bolt to drain the oil
from the crankcase.
6
1. Engine oil drain bolt (crankcase)
5. Remove the drain bolt to drain
the oil from the oil tank.
1. Engine oil drain bolt (oil tank)
6. Remove the oil filter element
drain bolt to drain the oil from the
oil filter element.
TIP
Skip steps 7–9 if the oil filter element
is not being replaced.
7. Remove the oil filter element
cover by removing the bolts.
1. Oil filter element drain bolt
2. Oil filter element cover bolt
8. Remove and replace the oil filter
element and O-rings.
TIP
Make sure that the O-rings are pro-
perly seated.
6-12
1. Oil filter element
2. O-ring
9. Install the oil filter element cover
by installing the bolts.
10. Install the oil filter element drain
bolt.
11. Tighten the oil filter element
cover bolts and the oil filter ele-
ment drain bolt to their specified
torques.
Tightening torques:
Oil filter element cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
Oil filter element drain bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
12. Install the engine oil drain bolts,
and then tighten them to their
specified torques.