Brake Light Switches - Yamaha big bear 250 YFM25BA Owner's Manual

1. Locknut
2. Brake lever free play adjusting bolt
d. Tighten the locknut at the brake lever.
e. Install the footboard.
TIP
When adjusting the rear brake lever free play:
G Be sure not to step on the brake pedal.
G Make sure the brake pedal does not move.
EBU24762

Brake light switches

The brake light, which is activated by the brake
pedal and brake levers, should come on just be-
fore braking takes effect.
The brake light switch for the brake pedal can be
adjusted as follows, but the other brake light
switches should be adjusted by a Yamaha dealer.
1. Remove the footboard. (See "Engine oil" on
page 8-11 for removal and installation proce-
dures.)
2. Turn the adjusting nut while holding the brake
light switch in place. To make the brake light
come on earlier, turn the adjusting nut in direc-
tion (a). To make the brake light come on lat-
er, turn the adjusting nut in direction (b).
1. Rear brake light switch
2. Rear brake light switch adjusting nut
3. Install the footboard.
8-34
8