Yamaha big bear 250 YFM25BA Owner's Manual page 96

a higher quality than specified. In addition,
do not use oils labeled "ENERGY CONSERV-
ING II" or higher.
G Make sure that no foreign material enters the
crankcase.
16. Start the engine, and then let it idle for several
minutes while checking it for oil leakage. If oil
is leaking, immediately turn the engine off and
check for the cause.
17. Turn the engine off, wait at least ten minutes,
and then check the oil level and correct it if
necessary.
18. Install the footboard by installing the bolts, and
then tighten them to the specified torques.
8
1. Footboard bolt A
2. Footboard bolt B
Tightening torques:
Footboard bolt A:
4.0 Nm (0.40 m·kgf, 2.9 ft·lbf)
Footboard bolt B:
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
19. Adjust the brake pedal free play. (See page
8-31.)
8-17