After Operation; After Operation Safety; Inspecting And Cleaning After Mowing; Hauling The Machine - Toro Greensmaster TriFlex 3300 Operator's Manual

Cutting the Periphery and
Finishing Job
1. Finish cutting the green by mowing the outer
periphery. Change the direction of cutting from
the previous mowing.
Note:
Always keep weather and turf conditions
in mind and be sure to change the direction of
mowing from the previous cutting.
2. When finished mowing the outer periphery, tap
the raise/lower mow lever rearward to stop the
reels, then drive off the green. When all the
cutting units are off the green, raise the cutting
units.
Note:
This minimizes grass clumps left on the
green.
3. Replace the flag.
4. Empty the grass baskets of all clippings before
transporting to the next green.
Note:
Heavy wet clippings place an undue
strain on the baskets and add unnecessary
weight to the machine, thereby increasing the
load on the engine, hydraulic system, brakes,
etc.

After Operation

After Operation Safety

General Safety
•
Clean grass and debris from the cutting units,
drives, mufflers, cooling screens, and engine to
help prevent fires. Clean up oil or fuel spills.
•
Shut off the fuel while storing or transporting the
machine.
•
Allow the engine to cool before storing the machine
in any enclosure.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
Inspecting and Cleaning
after Mowing
After mowing, thoroughly wash the machine with a
garden hose without a nozzle so that excessive water
pressure does not contaminate and damage the seals
and bearings. Do not wash a warm engine or the
electrical connections with water.
After cleaning the machine, perform the following:
•
Inspect the machine for possible hydraulic
fluid leaks, damage or wear to hydraulic and
mechanical components.
•
Inspect the cutting units for sharpness.
•
Lubricate the brake-shaft assembly with SAE 30
oil or spray lubricant to deter corrosion and help
keep the machine performing satisfactorily during
the next mowing operation.

Hauling the Machine

•
Use care when loading or unloading the machine
into a trailer or a truck.
•
Use a full-width ramp for loading the machine into
a trailer or a truck.
•
Tie the machine down securely using straps,
chains, cable, or ropes. Both front and rear straps
should be directed down and outward from the
machine.
25