After Operation; After Operation Safety; Inspecting And Cleaning After Mowing - Toro Greensmaster TriFlex 3300 Operator's Manual

1. Alignment strip
2. Approximately 12.7 cm (5
inches)
Note:
The steering wheel does not return to its
original position after you complete a turn.
Important:
Never stop the machine on a
green while the cutting units are engaged, as
damage to the turf may result. Stopping the
machine on a wet green may leave marks or
indentations from the wheels.
Cutting the Periphery and
Finishing the Job
1. Finish cutting the green by mowing the outer
periphery. Change the direction of cutting from
the previous mowing.
Note:
Use the throttle lever to adjust the
machine speed when you cut the periphery.
This will match the clip to the green and may
reduce triplex ring.
Note:
Always keep weather and turf conditions
in mind and be sure to change the direction of
mowing from the previous cutting.
2. When finished mowing the outer periphery, tap
the raise/lower mow lever rearward to stop the
reels, then drive off the green. When all the
cutting units are off the green, raise the cutting
units.
Note:
This step minimizes grass clumps left on
the green.
3. Replace the flag.
Figure 25
3. Cut grass on the left.
4. Keep a focal spot 2 to 3
m (6 to 10 ft) ahead of the
machine.
4. Empty the grass baskets of all clippings before
you transport the machine to the next green.
Note:
Heavy wet clippings place an undue
strain on the baskets and add unnecessary
weight to the machine, which increases the load
on the machine systems (e.g., engine, hydraulic
system, and brakes).

After Operation

After Operation Safety

General Safety
•
Engage the parking brake, shut off the engine,
remove the key, and wait for all movement to stop
g005116
before you leave the operator's position. Allow
the machine to cool before adjusting, servicing,
cleaning, or storing it.
•
Clean grass and debris from the cutting units and
drives to help prevent fires. Clean up oil or fuel
spills.
•
Shut off the fuel while storing or hauling the
machine.
•
Disengage the drive to the attachment whenever
you are hauling or not using the machine.
•
Allow the machine to cool before storing the
machine in any enclosure.
•
Maintain and clean the seat belt(s) as necessary.
•
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
Towing Safety
•
Tow only with a machine that has a hitch designed
for towing. Do not attach towed equipment except
at the hitch point.
•
Follow the manufacturer's recommendation for
weight limits for towed equipment and towing
on slopes. On slopes, the weight of the towed
equipment may cause loss of traction and loss of
control.
•
Never allow children or others in or on towed
equipment.
•
Travel slowly and allow extra distance to stop
when towing.
Inspecting and Cleaning
after Mowing
After mowing, thoroughly wash the machine with a
garden hose without a nozzle so that excessive water
25