Toro 30402 Operator's Manual page 16

To Remove Wing Deck Belts
2. To relieve tension on wing belt, pull back on idler
pulley until holes in idler adjustor tube and tube sleeve
are aligned. Thread a 5/16–18 capscrew into holes
retaining parts.
3. Remove hair pin cotter securing clutch rod to front of
cutting deck and disconnect rod from deck. Unplug
clutch wire from harness.
4. To ease wing belt removal, loosen or remove
stationary idler pulley next to wing's inner spindle pulley.
MAINTENANCE
To Remove Center Deck Belt
5. To relieve tension on center deck belt, pull back on
idler pulley until holes in idler adjustor tube and tube
sleeve are aligned. Thread a 5/16–18 capscrew into
holes retaining parts.
6. Wing deck belts must be removed before center
deck belt can be removed, repeat steps 1 – 3.
7. Remove (2) flange head screws securing drive
shaft cover to gear box support and remove cover.
8. Remove capscrews and nuts securing front of gear
box support to deck channels and loosen capscrews
securing rear of gear box support to deck channels.
9. Raise front of gear box support and remove old belt
from around gear box pulley and remaining pulleys.
10. Route new belt around appropriate pulleys as
shown in figure 25.
11. Remount gear box support to deck channels with
capscrews and nuts previously removed.
12. Reinstall drive shaft cover to gear box support with
(4) flange head screws previously removed.
16