Safety Doors - Toro 30402 Operator's Manual

2. Align the pivot arm
height–of–cut bracket holes in the deck frame, install
H.O.C. pin and secure with hairpin cotter.
REAR DECK STRAPS
1. Lower center and wing cutting units to the ground:
then raise center cutting unit slightly, until rear deck
straps hang freely on wear blocks of lift arm brackets.
Stop engine after cutting unit is raised.
2. Remove hairpin cotter and H.O.C. pin securing rear
deck strap to H.O.C. bracket on deck.
3. Slide deck strap forward or backward until holes in
strap are aligned with selected height–of–cut bracket
holes in the deck frame, install H.O.C. pin and secure
with hairpin cotter.
BEFORE OPERATING
holes with selected
9

SAFETY DOORS

(Fig. 8)
On each side of the center deck is a safety door that
opens and closes as the wing decks are lowered and
raised (Fig. 8). The doors open to provide overlap of the
cutting blades when the wing units are down. The doors
close to provide safety and protection when the wing
units are raised. Check to make sure the forward, lower
edge of door is even or 1/4" higher then lower edge of
door guide when wing decks are in the fully raised,
transport position. If an adjustment to the door is
required, refer to Adjusting Safety Door, page 36.