Table of Contents
Advertisement
Select The Proper Height–of–cut Setting To Suit
Conditions – Remove approximately one inch or no
more than 1/3 of the grass blade when cutting. In
exceptionally lush and dense grass you may have to
raise your height–of–cut setting another notch.
Mowing In Extreme Conditions – Air is required to cut
and recut grass clippings in mower housing, so do not
set height–of–cut too low or totally surround housing by
uncut grass. Always try to have one side of the mower
housing free from uncut grass, allowing air to be drawn
into housing. When making an initial cut thru center of
uncut area, operate machine slower and back up if
mower starts to clog.
Clippings Discharge – Although the deck has rear
discharge, some clippings are discharged toward the
left side. To avoid discharging undesirable clippings
onto pathways, roads, or other non–turf surfaces, mow
with the right side of the deck next to the pathway, road,
or other non–turf surface
OPERATING INSTRUCTIONS
Mow At Proper Intervals – Under most normal
conditions you'll need to mow approximately every 4–5
days. But remember, grass grows at different rates at
different times. This means that in order to maintain the
same height–of–cut, which is a good practice, you'll
need to cut more frequently in early spring; as the grass
growth rate slows in mid summer, cut only every 8–10
days. If you are unable to mow for an extended period
due to weather conditions or other reasons, mow first
with the height–of–cut at a high level; then mow again
2–3 days later with a lower height setting.
Always Mow With Sharp Blades – A sharp blade cuts
cleanly and without tearing or shredding the grass
blades like a dull blade. Tearing and shredding causes
the grass to turn brown at the edges which impairs
growth and increases susceptibility to diseases.
After Operating – To assure optimum performance,
clean underside of mower housings and under belt
covers after each use. Use low psi compressed air only.
Do Not Use Water. If residue is allowed to build up in
mower housings, cutting performance will decrease.
11
Advertisement
Table of Contents
