Mounting The Cutting Unit To The Traction Unit - Toro 30645 Operator's Manual

2. Remove the hairpin cotter and clevis pin securing the
height-of-cut rod to the rear of the cutting unit
20). Remove the height-of-cut collars.
2
1
Figure 20
1. Height-of-cut rod
2. Height-of-cut collar
3. Turn on the ignition switch and lower the cutting unit
to the floor.
Note: Leave the lift switch in the F
Note: Make sure the engine is not running.
4. Remove the hairpin cotters and clevis pins securing the
lift arms to the castor-arm brackets
1
2
3
4
Figure 21
1. Lift-arm
2. Clevis pin
5. Remove the hydraulic motor covers, remove the bolts,
then remove the hydraulic motor from the cutting unit.
(Figure 22).
(Figure
3
g017957
3. Hairpin cotter and clevis
pin
position.
LOAT
(Figure 21).
g017958
3. Hairpin cotter
4. Castor-arm bracket
1
g017959
6. Raise the lift arms, latch them in the raised position,
and roll the cutting unit away from the traction unit.
Turn off the ignition switch.
CAUTION
Do not engage the cutting unit drive while
the hydraulic motor is not connected to the
cutting unit.
Mounting the Cutting Unit to
the Traction Unit
1. Position the machine on a level surface and shut the
engine off. Leave the ignition switch on.
2. Move the cutting unit into position in front of the
traction unit.
3. Install the hydraulic motor onto the cutting unit, secure
it using the 2 bolts, then install the 2 hydraulic motor
covers (Figure 22).
4. Move the lift switch to the F
5. Push a lift arm down until the holes in the lift arm line
up with the holes in the castor-arm bracket and the
height-of-cut rod can be inserted into the lift-arm pads
(Figure 23).
18
2
3
Figure 22
position.
LOAT