Mounting The Rear Cutting Decks To The Traction Unit; Mounting The Front Cutting Decks To The Traction Unit - Toro 30845 Operator's Manual

1
1. Motor mounting screws
3. Remove the lynch pin securing the deck carrier frame
to the lift arm pivot pin (Figure 9).
1. Lift arm pivot pin
4. Roll the cutting deck away from the traction unit.
Mounting the Rear Cutting
Decks to the Traction Unit
1. Position machine on a level surface and shut engine
off.
2. Pivot the carrier frame forward and secure it to the
deck bracket with the flag pin, bolt and nut. Position
as shown in Figure 10.
g011619
Figure 8
Figure 9
2. Lynch pin
1. Carrier frame
2. Flag pin
3. Bolt and nut
3. Move cutting deck into position in front of traction
unit.
4. Slide deck carrier frame onto lift arm pivot pin.
Secure with lynch pin (Figure 9).
5. Install the hydraulic motor to the deck (Figure 8).
Make sure that the O-ring is in position and not
damaged.
6. Grease the spindle.
Mounting the Front Cutting
Decks to the Traction Unit
1. Position machine on a level surface and shut engine
off.
2. Pivot the carrier frame rearward and secure it to the
deck bracket with the flag pin, bolt and nut. Position
as shown in Figure 11.
10
Figure 10
4. Lift arm pivot pin
5. Lynch pin