Setup; Installing A Completion Kit; Installing The Castor Wheel Assemblies - Toro 30645 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
Media and Additional Parts
Description
Parts Catalog
Operator's Manual
DANGER
If the engine is started and you have not correctly
connected the hydraulic hoses, serious injury can
result.
You must make sure that the hydraulic hoses are
correctly connected or that blanking plugs have
been fitted before starting the engine and engaging
the cutting unit.
Note: Determine the left and right sides of the machine
from the normal operating position.
Description
Completion kit (sold separately)
Castor wheel assembly
Lift-arm, right
Lift-arm, left
Lift cylinder pin
Cylinder carriage bolt
Cylinder flange nut
Thrust washer
Clevis pin
Hairpin cotter
Height-of-cut collar
Clevis pin
Hairpin cotter
No parts required
No parts required
Qty.
1
2
1
1
2
2
2
4
4
2
2
2
2
–
–
Qty.
1
Read the contents of these materials and store them in
a safe location.
1
1

Installing a Completion Kit

Parts needed for this procedure:
1 Completion kit (sold separately)
Procedure
Install one of the following 62 inch or 72 inch completion kits
to the base deck using the instruction provided in the kit:
•
Model 30648, 62 inch Rear Discharge
•
Model 30306, 62 inch Guardian
•
Model 30649, 72 inch Rear Discharge
•
Model 30304, 72 inch Guardian
7
Use
Install a completion kit.
Install the castor wheel assemblies.
Install the lift arms.
Install the cutting units.
Connect the hydraulic drive.
Grease the machine.
Use