Table of Contents
Advertisement
Problem
Coffee dispensing
is repeatedly
interrupted and
the message "Fill
the coffee bean
container"
appears in the
display.
Drink dispensing
starts even though
a sensor has not
been touched.
Milk is dripping or
running out of the
central spout even
though no milk is
being dispensed.
Possible cause and remedy
This is not a fault.
The brew unit has not detected the ground coffee.
The coffee may be too finely ground or there may not be
enough of it. Usually this is because the grinder is set too fine
and the amount set is insufficient.
^ Confirm the message with OK.
Tip: If the coffee is too strong for you or it tastes bitter, try a
different type of bean.
If the display appears with all types of drink:
^ Set the grinder to a coarser setting (see "Coffee the way
you like it - Grinder setting").
^ Check the amounts of coffee set for all drinks (see "Coffee
the way you like it - Amount of coffee"). Select a higher
amount of coffee if necessary.
Don't forget to check any drinks changed in "Profiles" {.
If the messages only appears when dispensing certain
drinks:
^ Check the amount of coffee set for these drinks (see
"Coffee the way you like it - Amount of coffee"). Select a
higher amount of coffee if necessary.
^ You may also need to set the grinder setting a bit coarser.
Condensate may have built up on the control panel and
accidentally started the process.
^ Wipe any condensate off with a soft cloth.
The level of milk in the milk flask is higher than the central
spout.
^ Push the central spout up as far as it will go.
Problem solving guide
69
Advertisement
Table of Contents
