Removal Of Thermistor; Removal Of Motor Control Module - Fisher & Paykel SMARTDRIVE Service Manual

421827
8.7

Removal of Thermistor

(a) Follow the procedure for removal of
Console. (Refer to Section8.2).
(b) Disconnect the Display wiring harness from
the Motor Control module & place console
out of the way.
(c) Disconnect thermistor-wiring harness to the
Motor Control Module.
(d) Slide body of thermistor out from the valve.
Reassembly:
Refit in reverse manner, ensuring when refitting
the thermistor that the thermistor is pushed in
until it comes to a stop against the back wall of
the elbow.
8.8

Removal of Motor Control Module

(a) Follow the procedure for removal of
Console. (Refer to Section 8.2).
(b) Disconnect the Display wiring harness from
the Motor Control module & place console
out of the way.
(c) Disconnect all remaining wiring harnesses
to the Motor Control Module.
(d) Remove the pressure tube by squeezing on
the legs of the spring clip. Pull gently on
the tube to slide it off the spigot.
Note: If too much force is used on removal
or reinsertion, damage to the pressure
transducer may occur.
(e) Remove the screw holding the Motor
Controller from the front edge. Pull the tab
on the top deck harness clamp towards the
front to release the Motor Control Module.
(f) Lift the Motor Control Module upwards at
the front and out.
Reassembly:
Refit in reverse manner. Important: When refitting the pressure tube to pressure transducer
ensure that the pressure tube is clear of any water droplets before operating the machine on a fill
cycle. If the bowl is full of water, drain the water then blow down the tube.
Thermistor
56