Fisher & Paykel SMARTDRIVE Service Manual page 63

8.21.2 Hanning
(a) Tilt the rear of the machine carefully
against the wall ensuring that the machine
is stable and locked in position; take
necessary precautions not to damage the
wall or the machine.
(b) Remove the wiring harness to the pump
with the aid of a small slot screw driver.
Insert the screw driver into the terminal
cover slot and lever the connector out
carefully.
(c)
On recirculating product remove the
associated clamps, at the bowl end of the
pump to bowl hose and at the pump outlet
of the pump to diverter valve hose and
continue with step (e).
(d) On non recirculating product remove the
associated clamps, at the bowl end of the
pump to bowl hose and at the drain hose
connection of the pump.
(e) Release the pump from the bottom of the
tub by loosening off the rear screw and
removing the 2 front screws that hold the
pump bracket to the bowl.
While releasing the pump to bowl hose
from the bowl slide the bracket towards
the front of the machine until the bracket
is free of the rear screw.
Then remove the hose connected to the
pump outlet.
Reassembly:
(a) On non recirculating product, refit the drain hose, ensure that it is refitted through the hose
guide bracket, and clamp.
Taking care to not damage or puncture the drain hose with the hose guide bracket.
(b) For recirculating product refit the pump to circulation valve hose and clamp.
(c) Relocate the bracket correctly into the rear screw and fit the pump to bowl hose & clamp, then
refit and tighten the 2 front screws, once fitted ensure that the rear screw is tightened.
(d) Dress the pump harness through the clamp on the side of the bracket and reconnect to the
pump looping the harness as shown.
Test the drain pump operation to ensure there is no water leaks.
63
421827