Control Screen - Fisher & Paykel SMARTDRIVE Service Manual

5.2.4 Diverter Valve Test
The recirculation valve can be activated while in diagnostics, machine status mode, by highlighting
with the Scroll arrows
displayed state will change from "Off" to "Heating." Then by highlighting with the Scroll arrows
the COLD option and turning the cold water valve "On" with the Select
with water so the Water Level indicator on the LCD reads 100mm,. Once the water level reads
100mm turn off the cold water valve. Activate the pump by highlighting with the Scroll arrows
the PUMP option and turning it on with the Select
the rear right hand corner of the inner bowl. To turn the recirculation valve "Off" Scroll with the
arrows or and highlight the
displayed state will change from "On" to "Cooling", when cooled down it will change to "Off". The
diverter valve will take up to 3 minutes to cool and close before allowing the water to drain. Once
the water has drained turn off the pump.
5.2.5
5.3

Control Screen

Upon entering the control screen, the following will appear in the LCD display.
5.3.1 Hot Bowl Flag
If the machine has been filled utilising the hot water valve (i.e. warm or hot fill) and has not had a
cold rinse, the electronics will not allow the machine to spin up to its full speed of 1000 RPM. It will
only allow the spin speed to reach 700 RPM.
To remove this flag, enter the Control Screen mode, ensure the
and then touch Lifestyles/Options
putting the machine through a complete final rinse.
5.3.2 Restart Feature
The FabricSmart™ IW leaves the factory with the
screen by the word RESTART
scroll arrow . This will remove the highlight from the word RESTART.
When servicing the machine, it is more convenient to turn the RESTART feature OFF. This will
allow any fault in the system to show up immediately it occurs.
With the RESTART feature on: (Factory Default setting)
1. If a fault occurs in the machine, the diagnostic system will detect it. However, instead of
displaying a fault code immediately, the machine will try to RESTART.
2. If the fault was only of temporary nature, the machine will restart and finish the cycle.
3. If there is a continuous fault the machine will try to RESTART a number of times. This
process could take up to 8 minutes depending on the type of fault. After this, if the machine
still cannot restart, the fault code is displayed and the machine will beep continuously. The
number of retries will depend on the fault that it has detected, however the maximum
number or retries for any one fault is 32 times.
NOTE - This feature is designed as a service aid only and should be left ON in the
customer's home. To return to normal operation, and to reset the RESTART feature to the
factory setting, switch the machine off at the wall or disconnect from the mains supply.
or the DIVERTER
DIVERTER option turning it off with the Select
button. Alternatively this flag can also be removed by
highlighted. To turn the RESTART feature OFF, touch the Left
option and turning it on with the Select
button; the water should be circulating from
HOT BOWL
RESTART set to ON, this is indicated in the
31
421827
button. The
button, fill the Bowl
or
button, the
option is highlighted,
or