Storage - Toro 07359 Operator's Manual

Storage

1. Position the machine on a level surface, set the parking
brake, stop the engine, and remove the ignition key.
2. Clean dirt and grime from the entire machine, including
the outside of the engine cylinder head fins and blower
housing.
Important: You can wash the machine with mild
detergent and water. Do not use high-pressure
water to wash the machine. Pressure washing
may damage the electrical system or wash away
necessary grease at friction points. Avoid excessive
use of water, especially near the control panel,
lights, engine, and the battery.
3. Inspect the brakes; refer to
46).
4. Service the air cleaner; refer to
Cleaner (page 30).
5. Grease the machine; refer to
6. Change the engine oil; refer to
31).
7. Check the tire pressure; refer to
Pressure (page 20).
8. Flush the fuel tank with fresh, clean diesel fuel.
9. Remove the battery from the chassis.
Note: Do not connect the battery cables to the battery
posts during storage.
Important: The battery must be fully charged to
prevent it from freezing and being damaged at
temperatures below 0° C (32° F). A fully charged
battery maintains its charge for about 50 days
at temperatures lower than 4° C (40° F). If the
temperatures will be above 4° C (40° F), check the
water level in the battery and charge it every 30
days.
10. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged.
11. Paint all scratched or bare metal surfaces.
Paint is available from your Authorized Service Dealer.
12. Store the machine in a clean, dry garage or storage area.
13. Remove the ignition key and put it in a safe place out
of the reach of children.
14. Cover the machine to protect it and keep it clean.
Inspecting the Brakes (page
Servicing the Air
Lubrication (page 27).
Changing the Oil (page
Checking the Tire Air
50