Lubrication; Greasing The Machine - Toro 07359 Operator's Manual

Closing the Hood
1. Gently lower the hood onto the chassis.
2. Secure the hood by aligning the rubber latches onto the
latch anchors at each side of the hood

Lubrication

Greasing the Machine

(Figure 24).
Service Interval: Every 100 hours/Yearly (whichever comes
Grease Type: Number 2 general-purpose, lithium-base
grease
1. Use a rag to wipe the grease fitting clean so that foreign
2. With a grease gun, apply 1 or 2 pumps of grease into
3. Wipe the excess grease off the machine.
The grease fittings are located at the 4 tie-rod ends
25) and the 2 king pins
1. Grease fitting
1. Grease fitting (king pin)
27
first)—Grease the bearings and bushings.
Grease the machine more frequently
when using it for heavy-duty operations.
matter cannot be forced into the bearing or bushing.
the grease fittings on the machine.
(Figure 26).
Figure 25
Left side shown
Figure 26
Left side shown
(Figure
2. Tie rod