Engine Maintenance; Servicing The Air Cleaner - Toro 07359 Operator's Manual

8. Install the retainer over the nut and check the alignment
of the slot in the retainer and the hole in the spindle for
the cotter pin (Figure
Note: If the slot in the retainer and the hole in the
spindle are not aligned, tighten the spindle nut to align
the slot and hole to a maximum torque of 226 N-cm
(20 in-lb) on the nut.
Figure 33
1. Dust cap
2. Nut retainer
9. Install the cotter pin and bend each legs around the
retainer (Figure 33).
10. Install the dust cap onto the hub
11. Repeat the procedure for the hub and rotor at the other
side of the machine.
Installing the Brakes and Wheels
1. Clean the 2 flange-head bolts (3/8 x 1 inch) and apply
a coat for anti-seize compound to the threads of the
bolts.
2. Align the brake pads to either side of the rotor
28 ) and the holes in the caliper bracket with the holes
in the brake mount of the spindle frame
3. Assemble caliper bracket to the spindle frame
28) with the 2 flange-head bolts (3/8 x 1 inch), and
torque the bolts 47 to 54 N-cm (35 to 40 ft-lb).
4. Align the holes in the wheel to the studs of the hub
and assemble the wheel to the hub with the valve stem
outward (Figure 27).
Note: Ensure that the mounting surface of the wheel
is flush with the hub.
5. Secure the wheel to the hub with the lug nuts
27), and torque the nuts to 108 to 122 N-m (80 to 90
ft-lb).
6. Repeat the procedure for the brake and wheel at the
other side of the machine.
33).
3. Cotter pin
(Figure 33).
(Figure
(Figure
(Figure
(Figure

Engine Maintenance

Servicing the Air Cleaner

Service Interval: Every 100 hours
Every 200 hours
Note: Service the air cleaner more frequently (every few
hours) if operating conditions are extremely dusty or sandy.
Checking the Filter
1. Raise the cargo box and secure it with the prop rod;
refer to Raising the Cargo Box (page
2. Check the air-cleaner body for damage which could
possibly cause an air leak
Note: Ensure that the air-filter cover is sealing around
the air cleaner housing. Replace a damaged air-cleaner
cover or housing.
1. Dirt-ejection port
2. Latch
3. Air-filter cover
32). 3. Pull the latch outward and rotate the air-cleaner cover
counterclockwise
4. Remove the cover from the air-cleaner body.
5. Gently slide the air-filter element out of the air-filter
housing
dislodged.
Note: Avoid knocking the filter against the air-filter
housing.
6. Inspect the air-filter element.
•
If the air-filter element is clean, install the filter
element, refer to
•
If the air-filter element is damaged, replace the filter
element; refer to
30
(Figure 34).
Figure 34
4. Air-filter element
5. Air-filter housing
6. Back of the machine
(Figure 34).
(Figure 34) to reduce the amount of dust
Installing the Filter (page
Replacing the Air Filter (page
17).
31).
31).