Toro 07359 Operator's Manual page 35

Disconnecting the Parking-Brake Cable
1. At the bottom of the machine, remove the cable tie that
secures the parking-brake cable to the service brake
line (Figure 42).
2. Mark a rotation stripe on the forward jam nut for the
parking-brake cable
Note: Ensure that the forward-jam nut does not
rotate.
1. Cable tie
2. Parking-brake cable
3. Forward-jam nut
4. Brake-cable bracket
5. Rear-jam nut
3. Loosen the rear-jam nut and remove the cable from
the brake-cable bracket
4. Remove the cotter pin and the clevis pin that secure the
clevis for the parking-brake cable to the brake-actuating
lever and separate the cable from the lever
5. Repeat the procedure for the parking-brake cable at the
other side of the machine.
(Figure 42).
Figure 42
6. Front of the machine
7. Clevis
8. Cotter pin
9. Clevis pin
10. Brake-actuating lever
(Figure 42).
(Figure
Removing the Seats and Seat Bases
1. At the bottom of the machine, remove the 8
flange-head bolts and 8 washers that secure the seat
base to the floor plate and rear-cab channel
1. Flange-head bolt
2. Washer
3. Hole (rear-cab channel)
2. Carefully lift the seats, seat base, and parking brake
cables from the machine
Important: Note the routing of the parking-brake
cables along the chassis as you lift the seats and
seat base from the machine.
42).
35
(Figure
Figure 43
4. Hole (floor plate)
5. Front of the machine
(Figure 43).
Figure 44
43).