Hour Meter; Key Switch; Diagnostic Light - Toro 30859 Operator's Manual

Traction unit
Table of Contents

Advertisement

6
5
4
3
2
1
1. Throttle control
2. Enable/disable switch
3. Glow plug indicator light
4. Engine coolant
temperature warning
light

5. Diagnostic light

Key Switch

The key switch (Figure 10) has three positions: Off,
On/Preheat, and Start.
Engine Coolant Temperature Warning
Light
This light (Figure 10) illuminates and the mowers shut down
when the engine coolant reaches a high temperature. If the
engine temperature continues to rise, the engine will shut
down.
Engine Coolant Temperature Gauge
During normal operating conditions the gauge (Figure 10)
should be in the green range. Check the cooling system if the
gauge goes to the yellow or red range.
Diagnostic Light
It will illuminate should a system fault be recognized.
Lower Mow/Raise Control Lever
This lever (Figure 10) raises and lowers the cutting decks
and also starts and stops the mowers when the mowers are
7
8
9
G003956
Figure 10
6. Engine coolant
temperature gauge
7. Engine oil pressure
warning light
8. Charge indicator
9. Key switch
10. Lower mow/raise control
lever
enabled in the mow mode. When starting the decks in the
down position, this lever will turn the decks on if the PTO
and the mow speed limiter are engaged.
Glow Plug Indicator Light
10
This light (Figure 10) illuminates when the glow plugs are
preheating.
Engine Oil Pressure Warning Light
This light (Figure 10) indicates dangerously low engine oil
pressure.
Charge Indicator
The charge indicator (Figure 10) illuminates when the system
charging circuit malfunctions.
Enable/Disable Switch
Use the enable/disable switch (Figure 10) in conjunction with
the lower mow/raise control lever to operate the mowers.
The mowers cannot be lowered when the mow/transport
lever is in the transport position.

Hour Meter

The hour meter (Figure 11) shows the total hours that the
machine has been operated.
1. Hour meter
Hydraulic Filter Restriction Indicator
With the engine running at normal operating temperature,
view the indicator (Figure 12), it should be in the Green zone.
When the indicator is in the Red zone, change the hydraulic
filters.
17
Figure 11

Advertisement

Table of Contents
loading

This manual is also suitable for:

30861Groundsmaster 4300-d

Table of Contents