Adjusting The Throttle - Toro 30859 Operator's Manual

3. Remove the oil filter (Figure 41).
1. Oil filter
4. Apply a light coat of clean oil to the new filter seal.
5. Install the replacement oil filter to the filter adapter.
Turn the oil filter clockwise until the rubber gasket
contacts the filter adapter, then tighten the filter an
additional 1/2 turn.
Important: Do not over-tighten the filter.
6. Add oil to the crankcase; refer to Checking the Engine
Oil.

Adjusting the Throttle

1. Position the throttle lever forward so it is approximately
1/8 inch from the front of the control arm slot.
2. Loosen the throttle cable connector, on the throttle
cable, next to the injection pump lever (Figure 42).
1. Throttle cable pivot
2. Injection pump lever arm
Figure 41
Figure 42
3. High idle stop
4. Throttle cable connector
3. Hold the injection pump lever arm against the high
idle stop (Figure 42).
4. While pulling the throttle cable, to remove any slack,
tighten the throttle cable connector.
Note: When tightened, the cable pivot must be free to
swivel on the injection pump lever arm.
5. If the throttle does not stay in position during
operation, increase the torque on the locknut, used to
set the friction device on the throttle lever.
34