Setting The Clock; Setting And Using The Alarm/Previewing The Alarm And Turning The Alarm On/Off - iHome iBT38 Instruction Manual

Setting the Clock

1. Press and hold the
until the clock display flashes and a beep sounds.
2. Press the – or +
setting). Make sure you set the correct AM/PM time. The AM and PM indicators
appear to the left of the display.
3. To toggle the clock display between standard 12 hour time and 24 hour ("military") time display,
press the Alarm or
4. Press the Time Set Button to confirm the time and exit clock setting mode. 2 beeps will confirm
clock setting is complete.
Setting and Using the Alarm
This unit features dual alarms which can be set to different times and alarm sources. Each is set in the
same way. Instructions are given as "Alarm Button"; use
respective alarms.
Note: Each step must be completed while display is flashing or step will time-out with any changes
saved.
1. Press and hold the Alarm Button for 2 seconds until the time display and alarm icon flash. A beep
sounds.
2. Press the – or + Buttons to adjust the alarm time to the desired time (hold for rapid setting).
Make sure you set the correct AM/PM alarm time. The AM and PM indicators appear to the left of
the display.
3. Press the Alarm Button to confirm the alarm time setting. The wake-to source will flash.
Time Set Button located on the back of the unit for 2 seconds
Buttons to adjust the clock to the current time (hold for rapid
Alarm Button while the display is flashing during time setting.
Using the
Alarm Button or
6
iBT38
Alarm Button to set