Charging Devices Via Usb Port; Replacing/Installing Backup Batteries; Replacing/Installing Clock Backup Battery - iHome iBT38 Instruction Manual

Charging Devices via USB Port

1. Connect the standard size end of a USB cable (not included) to the
USB Port on back of the unit and connect the other end to the charging
port on your device.
2. Monitor the charging on your device. Some devices use a proprietary
charging method and will not charge using the USB Port. If this
happens, you must charge your device using the charger that came
with it.
Replacing and Installing Clock Backup Battery
The unit comes with 1 CR2450 back-up battery installed to provide
continuous alarm operation and clock settings in the event of a power failure.
Remove the battery pull tab before use. When the Battery Low
Icon located on the lower right of the display is flashing, it is time to replace
the back-up battery. The battery compartment is located on the bottom of the
unit.
1. Please make sure the AC adaptor is connected, otherwise all settings
may be lost during battery replacement.
2. Use a Phillips screwdriver to remove the battery compartment cover
located on the bottom of the unit.
3. Remove exhausted battery. Insert 1 CR2450 battery checking that the +
side is facing you. Replace the compartment door. Do not over tighten.
Note: Make sure you dispose of battery properly (see your local regulations).
WARNING: Lithium batteries can explode or cause burns if disassembled, shorted, recharged, exposed to water, fire,or
high temperatures. Do not place loose batteries in a pocket, purse, or other container containing metalobjects, mix with
used or other battery types, or store with hazardous or combustible materials. Store incool, dry, ventilated area. Follow
applicable laws and regulations for transport and disposal.
Using the
NOTE: Unit must be plugged
into working outlet to
charge devices
.66A
Replacing Backup Battery
13
iBT38