Setting The Clock; Setting The Alarms - iHome iHv330 Manual

INSERTING BATTERIES FOR MEMORY BACKUP
It is advisable to fit batteries (not supplied) in the battery compartment to prevent the loss of
the display time and settings during a power failure. During a power failure, the unit can save
the time.
1. Disconnect the radio from power.
2. Drive out the screw on the battery cover.
3. Remove the battery compartment door and insert 2 x AAA size batteries, matching the
polarity (+ and -) as shown in the battery compartment.
4. Replace the battery compartment door.
Note: When operating with batteries only, the display will be blank and the clock will only
remain accurate for a short period of time. The clock accuracy will decrease due to the voltage
drop of the backup batteries. It is important that the mains supply is restored as soon as
possible. If no backup batteries are installed or the power interruption is prolonged, you will
need to set the clock again.

SETTING THE CLOCK

1. Insert the the DC IN plug into the DC IN jack on the unit and insert the Adapter plug into AC
100~240V, 50/60Hz mains outlet. The clock time will appear on display.
2. If the PM indicator lights, it means the time is PM time, if the PM indicator is o , it means it is
the AM time.
3. While in OFF mode, press and hold the SET button, the hour digits will blink, press the
button to set the correct hour digits. Press the SET button to confirm the hour setting.
4. The minute digits will blink, press the
5. Press the SET button again to complete the clock setting.
NOTE:
If the Batt low indicator blinks, it means there are no batteries in the battery compartment, or
the batteries are low.

SETTING THE ALARMS

1.) Press the button to put the Radio into standby mode, the clock time will appear.
2.) Press the ALARM 1/
Radio AL1 mode, press the third time to cancel alarm setting.
3.) Press and hold the ALARM 1/
adjust desired hour digits. Press the ALARM 1/
4.) The minute digits will blink, press the
ALARM 1/ button to save the minute setting.
5.) The volume level will appear on display, press the
volume level. Press the ALARM 1/
NOTE: Using the ALARM 2/
STOP THE ALARM RINGING
When the alarm rings, press the
or
button once to select the Buzzer AL 1 mode, press again to select the
until the hour digits blinks, press the
button to save and finish Alarm 1 setting.
button and the same ways as above stated to set Alarm 2.
button to stop ringing.
button to set the correct minute digits.
button to save the hour setting.
or button to adjust desired minutes. Press the
or
4
or
button to adjust desired alarm
or
button to