Memory Skip Scanning - Yaesu FTM-3200DR Advance Manual

Memory Skip Scanning

When some memory channels are continuously active, you may wish to skip them during
scanning, but still have them available for manual selection.
To mask a memory to be skipped (only) during scanning, use the following procedure:
1. Set the radio to the Memory Recall mode by
pressing the [ V/M ( MW )] key repeatedly, as
necessary, until
appear on the right side of the display.
2. Rotate the DIAL knob to select the Memory
Channel to be skipped during scanning.
3. Press and hold in the [ MHz ( SETUP )] key for
one second, then rotate the DIAL knob to
select "SCAN SKP 40".
4. Press the [ MHz ( SETUP )] key, then rotate
the DIAL knob to select "SKIP". The current
Memory Channel will now be ignored during
scanning.
5. Press and hold in the [ MHz ( SETUP )] key for
one second to save the new setting and exit
to normal operation.
A blinking " " icon will appear when you recall
the "skipped" memory channel manually.
To reinstate a channel into the scanning loop,
select "OFF" in step 4 above, after first recalling
the currently blocked channel (the "Skipped"
channel is accessible via manual channel
selection methods using the DIAL knob in the
Memory mode, whether or not it is locked out of
the scanning loop).
FTM-3200DR Advance Manual
" " and a channel number
Scanning
VOL
SQL REV D/A M H z V / M
TXPO D W SETUP M W
VOL
SQL REV D/A M H z V / M
TXPO D W M W
SETUP
DIAL
DIAL
Blinks
Blinks
17