Memory Skip Scanning - Yaesu FTM-7250DR Advance Manual

Scanning

Memory Skip Scanning

When some memory channels are continuously active, you may wish to skip them during
scanning, but still have them available for manual selection.
To mask a memory to be skipped (only) during scanning, use the following procedure:
1. Set the radio to the Memory Recall mode by press-
ing the [ V/M ( MW )] key repeatedly, as necessary,
until "MR" and a channel number appear on the
right side of the display.
2. Rotate the DIAL knob to select the Memory Chan-
nel to be skipped during scanning.
3. Press and hold the [ MHz ( SETUP )] key, then rotate
the DIAL knob to select "SCAN SKP 40".
4. Press the [ MHz ( SETUP )] key, then rotate the
DIAL knob to select "SKIP". The current Memory
Channel will now be ignored during scanning.
5. Press and hold the [ MHz ( SETUP )] key to save the new setting and exit to normal op-
eration.
A blinking " " icon will appear when you recall the
u
"skipped" memory channel manually.
To reinstate a channel into the scanning loop, select
"OFF" in step 4 above, after first recalling the currently
blocked channel (the "Skipped" channel is accessible
via manual channel selection methods using the
DIAL knob in the Memory mode, whether or not it is
locked out of the scanning loop).
20