Table of Contents
Advertisement
Key Attributes Configuration (Option 9)
Before attempting to load or modify network data, obtain the current
configuration from your service provider. This configuration information
should show the Directory Numbers / Call Appearances, the features (with
their feature numbers), and the telephone button to which each Directory
Number / Call Appearance or feature is assigned.
Central office Button assignments fall into three major categories: Directory
Numbers, Call Appearances, and Features. If a manual configuration of the
set is desired, or if a rearrangement of the button assignments is desired, the
3
following method must be used.
Warning:
If the Features and CA/DN are moved to different buttons the next time a
download is done the button configuration will go back to the original switch
configuration and the manual assignments will need to be entered again. It
is probably better to have your service provider change the assignments in
the Central office switch and avoid changing them in the phone.
If you want to change a button assignment from one category to another
(i.e. Call Appearance to Directory Number), first clear the current assignment
and then make the new assignment. For changes within a category (e.g. –
feature such as call forwarding to call pick-up), simply replace the old data
with the new data.
To load, modify, or update your set' s network data, begin with these steps:
1. Press OPTIONS, numeric key "9", then ENTER.
2. Press ENTER.
Either download the configuration or setup each item manually. Each method
is described in the following sections.
Key Attribute selection 1, "Downloading" may be used to request a download
after initial installation.
3-6
KEY ATTRIBUTE MODE
1: DL
2:MANUAL
(SELECT 1-2)
Advertisement
Table of Contents
