Monitoring Function Of Wired Remote Controller - Toshiba MMD-AP0076BHP1-E Service Manual

Monitoring function of wired remote controller

The following monitoring function is available if the remote controller of RBC-ATM32E is used.
Content
Enter the service monitoring mode using the remote controller to check the sensor temperature or operation status of
the remote controller, indoor unit, and outdoor unit.
1
Push and hold the
mode.
The service monitor lights up. The temperature of CODE No.
2
Push the button to change to CODE No. of the item to monitor. Refer to the following
TEMP.
table for CODE No.
3
Push the left part of the
monitor. Monitor the sensor temperature or operation status of the indoor unit and outdoor
unit in the refrigerant line
4
Push the to return the display to normal.
TEMP.
2
TIMER SET
TIME
FILTER
RESET TEST SET
4 1
CL
, and for 4 seconds or longer to enter the service monitoring
UNIT LOUVER
button (left side of the buton) to change to the item to
– 49 –
ON / OFF
FAN MODE
SAVE VENT
CL SWING/FIX UNIT LOUVER
3
00 00 00 00 00
appears at first.