Wired Remote Controller - Toshiba RAV-GM561DTP-A Owner's Manual

3

Wired remote controller

This remote controller can control the operation of up to 8 indoor units.
■
Display section
In the display illustration below all the icons are shown. When the unit is in
operation, only relevant icons will be displayed.
• When the leak breaker is turned on at the fi rst time,
display part of the remote controller.
• While this icon is fl ashing, the model is being automatically confi rmed.
Wait till icon has disappeared to use the remote controller.
3
1
2
5
6
7
16
1
Operation mode
The selected operation mode is displayed.
2
Error display
Displayed while the protective device works or an
error occurs.
3
SETTING display
Displayed during setup of the timer or other
settings.
4
TEST run display
Displayed during a test run.
5
Timer display
The selected timer time is displayed.
When an error occurs, error code is displayed.
6
Timer mode display
The selected timer mode is displayed.
7
Filter display
Reminder to clean the air fi lter.
15-EN
fl ashes on the
TEMP.
TIMER SET FAN
TIME SAVE
FILTER
RESET TEST SET CL SWING/FIX
11
12
4 10
9
13
8
15
8
Fan speed display
The selected fan speed mode is displayed.
(Auto)
(High)
(Med.)
(Low)
9
Set temperature display
The selected set temperature is displayed.
10
Power saving mode display
Limits compressor speed (capacity) to save
energy.
5
Display
section
7
ON / OFF
16
Operation
MODE
VENT section
UNIT LOUVER
11
UNIT No. display
The selected indoor unit number is displayed.
Also number of indoor or outdoor unit which an
error occurs is displayed.
12
Central control display
Displayed when the air conditioner is used under
the central control in combination with a central
control remote controller.
In case the remote controller is disabled by the
1 7
central control system,
14
The button operation is not accepted.
Even when ON / OFF, MODE, or TEMP.
button is pushed, and the button operation is
not accepted. (Settings made by the remote
controller vary with the central control mode.
For details, refer to the Owner's Manual of the
central control remote controller.)
– 8 –
12
3 4
1
2
6
8
13
14
15
fl ashes.
16
17
11
10
9
13
17
14
15
Remote controller sensor display
Displayed while the sensor of the remote
controller is used.
Pre-heat display
Displayed when the heating mode is energized
or defrost cycle is initiated.
While this icon is displayed, the indoor fan stops.
No function display
Displayed when the function requested is not
available on that model.
Service display
Operation ready display
This display appears on some models.
16-EN