Thinning Out Hair; Trimming And Cutting Your Beard; Cutting Without An Attachment - Silvercrest SHBS 600 A1 Operation And Safety Notes

Note: Depending on how you hold the appliance and the angle this results in, the cutting
lengths may deviate from those mentioned in these instructions or the lengths marked on the
attachments.
Note: In order to improve cutting performance, place a drop of oil on the shaver head
This is particularly recommendable after cleaning. Wipe excess oil away with a cloth (see also
section called "Cleaning and care").

Thinning out hair

Q
This tool reduces the volume of the hair to produce a modern, straggly look without altering
the length of the hair.
j
I n order to thin the hair out, push the slide button
integrated in the trimmer head will then extend upwards.

Trimming and cutting your beard

Q
j
S et the desired cutting length depending on how long you want your beard to be. Now
gradually trim your beard.
Without a comb attachment

Cutting without an attachment

Q
CAUTION! RISK OF INJURY!
THE SHAVER HEAD
Remove the comb attachment
j
T urn the appliance round so you can see its back and push the comb attachment
upwards using the slide
j
U sing your thumb and index finger and with moderate force, push the comb attachment
carefully upwards and over the lateral locking pins. The comb attachment
released from the comb attachment fastening
j
R emove the comb attachment
Without a comb attachment
, the beard can be cut to a length shorter than 4 mm.
1
IS VERY SHARP!
2
(see Fig. A-C):
1
.
9
.
1
, the hair can be evenly cut to a length of 1 - 2 mm.
1
to the left; the thinning function
3
.
4
Use
.
2
2
1
1
will be
1
GB/CY 13