Thinning Your Hair; Cutting The Edges Of The Hairline, Neck And Sideburns; Trimming And Cutting Your Beard; Cleaning And Care - Silvercrest SHBS 1000 A1 Operating Instructions Manual

Thinning your hair

GB
IE
♦

Cutting the edges of the hairline, neck and sideburns

♦
♦
♦

Trimming and cutting your beard

♦
♦

Cleaning and care

♦
♦
10
You can use this function to reduce the volume of your hair because only part
of the hair is gripped and trimmed.
To thin your hair, clip the thinner add-on
front until it engages. When doing so, the thinner add-on
the trimmer head teeth.
Turn the appliance round so that the rear side is facing upwards.
Place the edge of the trimmer block
required height along the hairline.
Switch the hair and beard trimmer on and move it downwards.
Select a cut length add-on depending on the required beard length.
Now trim your beard in stages.
DANGER
Danger to life due to electric shock!
► Pull the power supply unit
appliance.
► Never touch the power supply unit
plugging it in or unplugging it.
► Always keep the power supply unit
CAUTION
Possible damage to the appliance.
► The hair and beard trimmer may never be immersed in water or other fl uids
for cleaning, since the appliance is not watertight. If this is done, live parts
(batteries) can be damaged.
► Do not use aggressive or abrasive cleaning agents, as these can damage
the upper surfaces.
► Clean the housing exclusively with a soft damp cloth and a mild dishwashing
liquid.
Switch the hair and beard trimmer off by pressing the ON - OFF switch
Disconnect the cable from the appliance and pull the power supply unit
of the power socket.
onto the trimmer block
8
without a cut length add-on
out of the power socket before cleaning the
6
with wet hands, especially when
6
and the cable dry.
6
from the
must protrude past
8
at the
7
3 .
out
6
SHBS 1000 A1