Table of Contents
Advertisement
GENERAL ASSEMBLY INSTRUCTIONS
A Philips head screw driver is required.
WARNING:
DO NOT PLUG IN POWER CORD TO POWER OUTLET. MAKE SURE PLUG
IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC.
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Undo the latches. (fig. 2)
3. Lift the power head off the collection tank. (fig. 3)
4. Remove the contents from inside the collection tank. Make sure you have all contents as listed
on page 5. (fig. 4)
5. Turn the collection tank upside down and insert the four caster feet into the slots on the
collection tank and tighten with supplied screws. Verify that the casters are mounted correctly.
Do not over-tighten the screws. (fig. 5)
6. For dry vacuum cleaning, install the supplied dust filter. (fig. 6) See page 11 for filter
installation.
7. For wet vacuum cleaning, install the supplied foam filter. (fig. 7) See page 11 for
filter installation.
8. Place the power head back on the collection tank, aligning the top section with the clasps, and
snapping into place by applying downward pressure. (fig. 8)
9. Insert the locking end of the hose into the port of the collection tank and turn to lock in to
place. (fig. 9)
10. Choose the desired accessories and push onto the suction tube. (fig.10)
POLARIZED PLUG
To reduce the risk of electrical shock, this appliance has a polarized plug (with one blade wider
than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in
the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper
outlet. Do not change the plug in any way. Double insulation
three wire grounded power cord and grounded power supply system.
6
eliminates the need for the
Advertisement
Table of Contents
