Download Table of Contents Print this page

Frigidaire FFEW2415QB Use & Care Manual page 15

Electric wall oven
Hide thumbs Also See for FFEW2415QB:


Table of Contents
Aluminum Foil, Aluminum Utensils, and Oven
Never cover any slots, holes, or passages in the oven
bottom or cover an entire oven rack with aluminum foil or
any other materials. Doing so blocks air flow through the
oven and may cause carbon monoxide poisoning.
Aluminum foil linings may trap heat, causing a fire hazard.
Protective liners—Do not use aluminum foil or any other
materials to line the oven bottom. The high heat of the
oven can melt these materials to the oven cavity and
ruin the oven. These types of materials can also reduce
the effectiveness of the air circulation in the oven and
produce poor baking results. Only use aluminum foil as
recommended in this manual. Improper installation of
these liners may result in risk of electric shock or fire.
Aluminum utensils - The melting point of aluminum is
much lower than that of other metals. Care must be
taken when aluminum pots or pans are used.
Oven racks - Do not use aluminum foil to cover the oven
racks. Using a liner in the oven restricts the heat and air
flow needed to obtain the best possible cooking results
for any oven.
Adhere to the following precautions when using spray
oven cleaners:
Do not spray cleaner on the electrical controls or
switches because it could cause a short circuit and
result in sparking or fire.
Do not spray any cleaner on the oven door trim or
gasket, handles or any exterior surfaces of the range,
plastic or painted surfaces. The cleaner can damage
these surfaces.
Replacing the Oven Light
Be sure the oven is unplugged and all parts are cool
before replacing the oven light.
The interior oven light is located at the rear of the oven
cavity and is covered by a glass shield. The glass shield
must be in place whenever the oven is in use
To replace the oven interior light bulb:
1. Turn electrical power off at the main source or unplug
the appliance.
2. Remove interior oven light shield by turning a quarter
turn counter-clockwise.
3. Replace bulb with a new T-4 type Halogen 25 watt
appliance bulb.
Wear a cotton glove or use a paper towel when installing
a new bulb. Do not touch the new bulb with your fingers
when replacing. This will shorten the life of the bulb.
4. Replace glass oven light shield by rotating clockwise.
5. Turn power back on again at the main source (or plug
the appliance back in).
6. Be sure to reset the time of day on the clock
Figure 10: Wall oven Halogen light


Table of Contents

This manual is also suitable for:


Table of Contents