40 °C 55 °C E 65 °C 82 °C Example SH 10 SL | SH 10 SLi: If an engineer is called out for a problem, to Temperature setting: 65 °C help him resolve this problem quickly and effi-...
KV 307 / KV 40 safety group at max. swivel arm. Do not use a perlator or hose • Positioning the thermostat/temperature 10 l/min. for the SH 10 SL(i), and 12 l/min. with jet regulator. limiter sensor in the protection pipe: with the SH 15 SL(i).
Page 6
• Descaling: • Checking earth conductor in accordance: Remove heating flange, remove coarse scale Disconnect the plug and remove the thermos- by careful tapping, immerse heating element tat. Test at the thermostat fixing screw and in limescale remover up to the flange plate. earth contact of the connection cable.
3. Defect Rectification for the user and engineer Defect Cause Solution No hot water despite hot water No power. User / Engineer: Check fuses on domestic system. tap being fully open. Limescale on jet regulator. User / Engineer: Clean or replace jet regulator on fitting. Temperature limiter (STB) has Engineer: Rectify the cause of the fault (replace thermostat)
Need help?
Do you have a question about the SH 10 SL and is the answer not in the manual?
Questions and answers