Disabling The Firewall Before Installing Your Printer; Inserting The Drivers And Utility Cd - Dell 1350cnw User Manual

2 Select TCP/IP Settings from the list on the left side of the page.
The TCP/IP Settings page appears.
If the IP address shows 0.0.0.0 (the factory default) or 169.254.xx.xx,
an IP address has not been assigned. To assign one for your printer, see
"Assigning an IP Address (for IPv4 mode)" on page 39.

Disabling the firewall before installing your printer

NOTE:
For Windows XP, Service Pack 2 or 3 must be installed.
If you are running one of the following operating systems, you must disable
the firewall before installing the Dell printer software:
• Windows 7
• Windows Vista
• Windows Server 2008 R2
• Windows Server 2008
• Windows XP
1 Click Start
NOTE:
use Online Help, switch to Offline Help on Windows Help and Support
window.
2 In the Search box, type firewall and then press Enter.
In the list, click Turn Windows Firewall on or off and then follow the
instructions on the screen.
Enable the firewall after the installation of the Dell printer software is
complete.

Inserting the Drivers and Utility CD

1 Insert the
Navigator.
NOTE:
(for Windows Vista and Windows 7)
Windows 7)
is the drive letter of your CD), and then click
54
Installing Printer Drivers on Computers Running Windows
Downloaded from ManualsPrinter.com Manuals
Help and Support.

For Windows Server 2008 R2 and Windows 7 operating systems, if you
Drivers and Utilities
If the CD does not automatically launch, click
 Run
, and then type
CD into your computer to start Easy Setup
Accessories
D:\setup_assist.exe
OK
.
Start  All Programs
(for Windows Vista and
(where D