Advanced Menu - Getac v100 User Manual

Advanced Menu

The Advanced menu contains the advanced settings as shown next.
Main Advanced
SATA Mode Selection:
Digitizer Type:
Serial port COM1:
Serial port COM2:
Serial port COM4:
Boot-time Diagnostic Screen:
F1 Help
↑↓
Esc Exit
←→
SATA Mode Selection sets the mode to enhanced
Controller Interface) or
SATA AHCI mode is enabled.
Digitizer Type or TouchScreen (actual item shown depends on your model)
Digitizer Type allows you to select the type of digitizer you are using.
TouchScreen allows you to unconditionally disable it when set at
Disabled
.
Serial Port COM1/COM2/COM4 allows you to unconditionally disable it
Disabled
when set at
Boot-time Diagnostic Screen allows you to display the diagnostic screen
during system boot-up.
Downloaded from LpManual.com Manuals
Security
[AHCI] AHCI
[AIP1040]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
Select Item -/+
Select Menu Enter
IDE
. Turbo memory feature works only when the
.
Boot Exit
Item Specific Help
Determines how SATA
controller(s) operate.
NOTE: Turbo memory
function need to enable
SATA AHCI mode. If not
Turbo memory does NOT
have function.
Change Values
Select Sub-Menu

AHCI
F9 Setup Defaults
F10 Save and Exit
(Advanced Host