EverFocus PARAGON 264x4-16 Instruction Manual page 49

Normal Speed: Frame rate in images per second (IPS) for continuous recording. The speed is limited to
the maximum recording rate of the DVR (displayed in the bottom left corner) divided by the number of
installed cameras. If the resolution option is changed, the value (fps) shown next to this field will also
change. The number here indicates the remaining recording capacity available for all 16 cameras. When
this number is positive, it means there is still recording capacity. If this number is negative, it means the
recording capacity has been exceeded, and the user must lower Normal Speed or Resolution. This number
must be positive before saving the changes. Otherwise, a pop-up window will display "Total FPS exceed
maximum recording rate, discard changes!" and the settings for all cameras will return to previous values.
Hint: If less than 16 cameras are installed, the checkbox "Installed" should be deactivated for the idle input
signals, as also idle input signals affect the calculation of the remaining framerate!
Event Speed: Frame rate in images per second (IPS) for event recording, adjustable from 1 to 25 IPS. If
more than one camera requires event recording at the same time, the available speed is distributed among
the respective number of cameras.
Record audio: Activate the checkbox to enable audio recording for this channel.
PTZ ID: When using a PTZ Camera connected through RS-485 interface, enter the PTZ ID from 001 ~ 255
or OFF (OFF corresponds to 000). This ID must match the ID used by the connected camera in order to
control the camera using the DVR.
Apply To: Select this button to copy the recording settings to other cameras. In the following dialogue,
activate the checkboxes for all cameras you wish to copy the settings to and click "OK" to copy the settings.
"Select All" selects all cameras, "Unselect All" deselects all cameras. Click "Cancel" to exit without copying.
43