Hoover U57809RM Windtunnel Cyclonic Owner's Manual page 6

Cord
Rewind
2-4
A
To return cord for storage, hold plug
and press on button (A) at top of cord
reel. To prevent cord from whipping,
hold plug until cord is rewound.
Carpet Height
Adjustment
2-7
A
B
various carpet pile heights, turn
the nozzle control knob (B) to the
desired setting.
Agitator Brush Roll Shut-Off
2-9
Transporting
Cleaner
Grasp the end
2-5
of the plug
and pull to
release cord
from cord
reel. After
desired cord
length is
reached, the
cord will lock
into position.
To move your cleaner
from room to room,
put handle in upright
position, tilt cleaner
back on rear wheels
and push forward.
Settings
The cleaning
2-8
of carpet and
rugs takes
place at the
nozzle (A).
When it is
necessary
to raise and
lower the
nozzle for
pile carpet, where easier pushing effort is desired, while
maintaining good cleaning performance.
The agitator brush roll shuts off automatically for tool use,
when the cleaner is in the upright position.
B
A
To manually shut off the agitator brush roll for cleaning hard
floors, step on the pedal (A). The indicator (B) will show red
in the "brush roll off" window. To turn the agitator brush roll
on, step on the pedal again. The indicator will show red in the
"brush roll on" window.
Handle
Positions
2-6
position for general operation on
carpet and floors; low for reaching
under low furniture. Step on handle
release lever to lower handle.
For maximum cleaning performance,
the following carpet height settings
are recommended:
• Lowest setting: for all types of
carpet.
Note: If the cleaner is difficult to
push, turn knob to the next higher
setting.
• Higher settings: for very deep
6
The handle
of your
cleaner
has three
1
2
positions;
upright for
storage and
when using
3
cleaning
tools;
operating