Headlight - Hoover U57809RM Windtunnel Cyclonic Owner's Manual

Filters (cont.)
Secondary Filter: How to Clean
Disconnect cleaner from electrical outlet. Do not use cleaner without dirt cup or filters in place.
4-8
A
Secondary Filter: What to Buy
When purchasing a new secondary filter cartridge, ask for HOOVER part No. 93002517.
To purchase a new black foam filter, ask for HOOVER part No. 93002518.
HEPA Final Filter: How to Clean
Disconnect cleaner from electrical outlet. Do not use cleaner without dirt cup or filters in place.
4-9
A

Headlight

Disconnect cleaner from electrical outlet.
Removing Lens
4-10
Press handle release pedal and place handle
in low position.
Using a Phillips screwdriver, remove the the
screw as shown and lift off lens.
Headlight: What to buy
This cleaner uses a 13 volt, T-3 114 wedge
base bulb, When purchasing a new lightbulb,
ask for Hoover part No. 27313-107.
With fingers in slots, pull filter
frame (A) straight out.
Dirt and debris can be cleaned from
the filter cartridge by brushing with
the cleaner's combination tool.
DO NOT RINSE OR WASH the
HEPA filter cartridge.
Slide back into position on cleaner.
Remove dirt cup as described in Fig. 4-2.
With thumb and forefinger, slide latch (A) located at the
top of the housing to the right and pull down to remove
gray filter frame. Remove black foam filter. Rinse filter
frame cartridge and foam filter under cold water.
Allow both filter frame and filter to air dry for 24 hours
before replacing filter into filter frame. Reposition filter
frame cartridge by inserting tabs into slots on back of
housing. Rotate filter cartridge frame up toward top of
housing and snap closed.
HEPA Final Filter: What to Buy
When purchasing a new HEPA filter
cartridge, ask for HOOVER part No.
93002360.
Installing Bulb
4-11
Pull old bulb straight
out of socket. Push
new bulb straight
into socket until
locked in place.
Excessive force is
not required.
10
Replacing Lens
4-12
Reposition lens and
secure with the screw.