Table of Contents
Advertisement
4.
Detach the rear-facing webcam from the back cover. (The rear-facing webcam is attached to
the back cover with double-sided adhesive.)
5.
Disconnect the RF antenna cable (1) from the antenna terminal on the system board.
6.
Disconnect the front-facing webcam cable (2) from the system board.
7.
Release the ZIF connector (3) to which the volume button board cable is attached, and then
disconnect the volume button board cable from the system board.
8.
Disconnect the connector board cable (4) from the system board.
9.
Remove the Phillips PM1.4×2.5 screw (1) that secures the system board to the back cover.
10.
Remove the system board bracket (2).
28
Chapter 5 Removal and replacement procedures
Advertisement
Table of Contents
