Table of Contents
Advertisement
Remove the speakers:
1.
Remove the Phillips PM1.4×2.5 screw (1) that secures the battery cable bracket to
the system board.
2.
Remove the battery cable bracket (2).
3.
Disconnect the battery cable (3) from the system board.
4.
Remove the two Phillips PM1.4×2.5 screws (1) that secure the top speaker to the back cover.
5.
Disconnect the bottom speaker cable (2) from the system board.
6.
Remove the speakers (3).
Reverse this procedure to install the speakers.
20
Chapter 5 Removal and replacement procedures
Advertisement
Table of Contents
